A customer of ours made this video of the amazing results he got with BBInfinite's bottom bracket technology that cures PressFit bottom bracket creaking and spins like crazy. Check out our PressFit 30, PressFit 30A, BB30, BB30A, Trek BB90, and other products and models at bbinfinite.com. Why doesn't your BB30 crank spin like this? Does it creak? It will spin like mad in absolute silence with the BBInfinite BB30 module for 30mm spindles. Let's install one now. Oh, and if you've got a Shimano, Gxp, or Campagnolo crank in your BB30 bike, head on over to BBInfinite.com to see our full line up. I've already removed the crank, the bearings, and the snap rings so that the BBInfinite module can go through unobstructed. We just start it by hand and it'll stay right there. Without any grease or Loctite on the module, we're going to begin pressing. We're going to use our BBInfinite Master Tool Press for this. All I did was throw the crank in the freezer for an hour or so and this will make it slide in a lot easier and I won't have to use a hammer, and it allows the wave washer to compress correctly. I would have had to use a hammer there. Let's get this bolted together before it thaws out. Well, there you have it, BBInfinite has cured all that ails BB30 and BB30A. Now all you need to do is to get one for yourself. Visit BBInfinite.com to get your BB30 solution today.
Comments will be approved before showing up.